Hints for optimum etching results:

1. Do not etch glass in direct sunlight on very hot days.
2. Do not etch glass when the temperature is below 45 degrees Fahrenheit.
3. Do not etch glass in very windy or wet conditions.
4. For a higher contrast etch, paint may be added after etch process is complete.

** DOUBLE CHECK YOUR VIN STENCILS WITH YOUR VIN NUMBER **

Auto Etch is not responsible for the wrong VIN number etched into your vehicle's glass!

If the stencils are not correct, call Auto Etch at 1-888-288-6382.

Recommended areas to be etched:

FRONT WINDSHIELD - drivers side in lower corner by factory VIN number.

SIDE WINDOWS - lower corner, near door lock or handle.

REAR WINDOW - driver’s side in lower corner or directly in middle of window, lower edge.

Clean area to be etched with glass cleaner.

Remove the blue stencils from the white backing paper and apply to the outside of window glass in the desired locations. With fingertips, gently "pat" the stencil to ensure that it is in full contact with glass, paying specific attention to the area where the VIN number has been cut into the stencil.

Apply a film of etch cream.

Brush both left and right completely covering all characters.

CAUTION: BE CAREFUL NOT TO SPREAD ETCHING CREAM OVER EDGES OF STENCIL ONTO GLASS SURFACE. IF YOU DO, WIPE OFF EXCESS IMMEDIATELY WITH PAPER TOWEL AND PLAIN WATER.

After etching cream has been on for 5 to 7 MINUTES:

Carefully remove and discard all stencils into a plastic bag or container
Spray etched area with plain water or glass cleaner and wipe dry with paper towel. Repeat process for all windows.

Warning decals.

Apply to inside of windows in conspicuous locations.

Suggested location: near handles on front doors. Avoid skin contact with label adhesive. We recommend using a knife blade or tweezers to apply label to required area. You may also fold back one corner of the decal liner. Position label as desired. Apply pressure to section of label where liner was peeled back to secure position. Peel liner from label, applying pressure with fingertips to label for maximum bonding.

Insurance "Proof of Etch" certificate.

Complete and mail one copy to your agent or company. Retain one copy for your records.

Etch highlight/contrast paint (optional).

Apply etch highlight/contrast paint with end of Q-Tip. Wait 1 to 2 minutes and remove excess paint with the flat side of a razor blade against glass. Lightly buff with a soft cloth. Paint may be re-applied as needed.

DANGER: KEEP ETCH CREAM OUT OF REACH OF CHILDREN

Harmful or fatal if swallowed. Skin and eye irritant. Avoid contact with skin. For skin contact, wash thoroughly with soap and water for 5 minutes. Wear protective gloves. Avoid eye contact. In case of eye contact, flush thoroughly with tap water for 15 minutes. If swallowed, rinse mouth with water and drink milk or Milk of Magnesia. Do not induce vomiting. Get prompt medical attention. Active ingredient 20% ammonium Bifluoride. Inert ingredients 80%.